P2A44
Alternative Fuel Tank B Pressure Sensor Circuit High
The counterpart to P2A43: the voltage on the tank B pressure sensor signal sits above its valid range. TransEco, for the tank A sensor of its gas conversions, names an open sensor or a short to power as the cause of the High code, which matches the usual pull-up layout of such inputs where a broken signal or ground wire drives the reading upward. A seemingly overfull cylinder is the risk here: the gauge may stay at full and the module may keep drawing on tank B as if gas were left, until the engine stumbles. No manufacturer lists P2A44 publicly, and the tank A variant P01A1 appears in Ford's 2014 Boss 302S code list. Start the check with the sensor ground and the plug, then measure signal voltage with the system depressurised.
Possible causes
- Sensor ground or signal wire open high
- Signal wire shorted to 5 V or battery voltage medium
- Tank B sensor faulty internally medium
Symptoms
- Check engine light
- Gauge stuck at full for tank B
- Stumbling when tank B actually runs empty
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A44
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.