OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A3C

O2 Sensor Negative Current Control Circuit Low Bank 1 Sensor 3

P2A3C is stored when the virtual-ground return belonging to the third probe of bank 1 falls below its intended bias. Because this line normally floats around 2.5 V rather than at chassis potential, a chafed wire touching the body or an exhaust bracket drags it down and leaves the pump cell little room to reverse its current, so rich mixtures can hardly be measured. No manufacturer publishes P2A3C; this text relies on CARB's demand to detect out-of-range sensor circuits, on the Bosch LSU 4.9 pin layout and on the bias value Saab gives for its 2010 9-5 at the plug. P2A3B is the open return, P2A3D the high case, P2A39 the matching low fault on the pump lead. The lamp is lit and the downstream sensor checks will not complete.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 3C

Possible causes

  • Virtual-ground wire chafed through to chassis ground high
  • Internal short from the common electrode to the sensor housing medium
  • Bias stage in the engine control module faulty low

Symptoms

  • Check engine light after repeated detection
  • Downstream emission monitors stay incomplete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A3C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication