OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A3B

O2 Sensor Negative Current Control Circuit/Open Bank 1 Sensor 3

P2A3B points to a break in the negative current control line of wide-band sensor 3 on bank 1, the common return of pump and Nernst cell. Bosch calls it virtual ground (IPN/VM, pin 2 on the LSU 4.9), NTK names it COM; the controller holds it at a bias of about 2.5 V, as Saab's 2010 9-5 shows at the plug, so current can flow both ways. No manufacturer documents P2A3B publicly. On the upstream analog P2251, Ford tells an open return from an open pump lead because lambda still shifts during reference-current pulses, and it flags a sensor voltage parked inside a band of 1.45–1.55 V, allowing 10 s before the fault is stored. P2A3C/P2A3D are low/high, P2A38 is the open pump lead. Expect the lamp, not a drivability change.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 3B

Possible causes

  • Broken virtual-ground wire or loose pin in the sensor plug high
  • Corroded terminals in the connector near the rear exhaust medium
  • Internal break of the common electrode inside the probe low

Symptoms

  • Check engine light
  • Sensor 3 signal stuck around its mid voltage in live data
  • Catalyst or aftertreatment monitor not completed

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A3B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication