P2A39
O2 Sensor Positive Current Control Circuit Low Bank 1 Sensor 3
P2A39 is set when the pump-current lead feeding the rearmost wide-band probe on bank 1 (sensor 3) is pulled below its permitted window, typically because the wire rubs through to chassis ground near the hot rear exhaust section. At ignition-on Saab's 2010 9-5 shows roughly 2.8 V on the pump-current pins of its front probe, so a reading near zero points to a ground short. No manufacturer publishes P2A39 itself; Ford stores a short to ground on the IP wire of its front probes under P0131, and CARB only requires that such out-of-range signals be caught. P2A38 covers the open line, P2A3A the high side, P22AC the sensor 2 case. Apart from the warning lamp, the aftertreatment monitors using this probe stay incomplete.
Possible causes
- Pump-current wire chafed through to body or exhaust bracket high
- Internal short in the probe after thermal shock or water ingress medium
- Faulty sensor interface in the engine control module low
Symptoms
- Check engine light after repeated detection
- Sensor 3 reading implausible or missing in live data
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2A39
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.