P2A36
AFCM Power Relay Sense Circuit Low
P2A36 is set when the relay feeding the gas control module has been commanded on, yet the voltage read back after its contacts stays too low. Burnt or pitted contacts, a high-resistance joint, a grounded sense wire or a blown fuse in the switched path all lead there, as does a weak battery during cranking. For the comparable engine relay code P0689, GM Europe on the 2010 Saab V6 uses a limit of 6 V held for more than 1 s and treats the result as Type C. No public calibration names P2A36 for a gas system. If the module really runs short of voltage, it may reset or drop off the network, which Roush's Ford propane trucks report as U0108; in a bi-fuel car the engine then returns to petrol.
Possible causes
- Worn or burnt relay contacts high
- Blown fuse in the switched supply medium
- Sense wire shorted to ground medium
- Weak battery or poor main ground low
Symptoms
- Check engine light, depending on calibration
- Gas mode drops out, bi-fuel vehicle switches to petrol
- Communication fault with the gas module stored as well
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2A36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-v6/fault-diagnosis-diagnostic-trouble-codes/dtc-p0685-p0686-p0687-p0689-or-p0690
- roushcleantech.com/wp-content/uploads/sites/all/themes/roushcleantech/pdf/diagnosticmanuals/Roush_CleanTech _Diagnostics_Manual-DA_8.5.18.pdf