P2A35
AFCM Power Relay Sense Circuit
Besides driving the relay coil, a control module can read back the voltage behind the relay contacts to confirm that power actually arrives. P2A35 is the general fault of this feedback line for the relay that supplies the gas control module, without a statement about too low or too high. Typical are an open sense wire, a corroded pin or a blown fuse between contact and sense point. Roush CleanTech's propane manual for Ford trucks lists a missing supply, a blown fuse or lost power and ground of its alternative fuel module as reasons for losing it on the bus (U0108), which shows how supply problems surface there. No published calibration uses P2A35; the engine-relay sibling P0688 is the analogue. Electrical symptoms may be absent while the relay itself still works.
Possible causes
- Sense wire open or pin backed out high
- Blown fuse between relay contact and sense point medium
- Corroded terminals in relay socket or module plug medium
Symptoms
- Check engine light, depending on calibration
- Often no drivability change
- Occasional fallback to petrol if the supply really drops
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2A35
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.