OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A34

AFCM Power Relay Control Circuit High

With P2A34 the coil control line of the gas module power relay stays at high voltage even when the driver tries to pull it to ground. Either the wire has contact with a battery-fed circuit, or the coil draws so much current that the driver shuts itself off for protection. In both cases the relay does not close. The consequence is the opposite of P2A33: the alternative fuel module receives no switched supply, so gas operation is impossible, and a bi-fuel car falls back to petrol from the start. Public documents for P2A34 are lacking; GM Europe treats the engine version P0687 on the 2010 Saab V6 with the same comparison of commanded against measured state. Ford's 2003 bi-fuel CNG design shows that the AFCM is a separate unit with its own power and relay outputs.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 34

Possible causes

  • Control wire shorted to a battery-fed circuit high
  • Relay coil with too low resistance overloading the driver medium
  • Wrong relay type fitted after a repair low

Symptoms

  • Check engine light, depending on calibration
  • Gas operation unavailable, bi-fuel vehicle runs on petrol only
  • Dedicated gas engine: cranks but does not start

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A34

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication