OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A33

AFCM Power Relay Control Circuit Low

P2A33 concerns the control line that grounds the coil of the relay supplying the gas control module. Low means this line already sits near zero volts while the driver is switched off. A chafed wire touching the body is the classic finding; a coil with shorted windings can give the same picture. Since the coil is then permanently grounded, the relay may stay energised after the key is off, keeping the gas module awake and draining the battery overnight. Nobody publishes this code for a production gas system. Saab's GM Europe V6 manual, written for the engine relay twin P0686, lets the test run only between 10 and 18 V supply with the engine turning above 80 rpm and classes it as a Type C code, meaning no warning lamp there. CARB expects actuator outputs to be checked for such shorts.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 33

Possible causes

  • Control wire chafed through and touching ground high
  • Shorted turns in the relay coil medium
  • Moisture in the relay socket bridging to ground low

Symptoms

  • Check engine light, depending on calibration
  • Battery flat after the vehicle has been parked
  • Gas module stays active after ignition off

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A33

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication