OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A2F

Alternative Fuel Tank Shutoff Valve E Control Circuit Performance/Stuck Off

P2A2F signals that valve E was energized but the system did not see the expected gas flow from that cylinder. No manufacturer publishes this code or its test conditions; CARB only requires output components to be checked for a proper reaction to commands. New Flyer's bulletin explains that its tank solenoids switch on while the starter spins the engine to about 400 rpm. A weak battery or a voltage dip during cranking can therefore leave a coil unable to lift its armature, which looks exactly like a valve that hangs shut. GM's bi-fuel Impala regulates gas to 468 to 896 kPa, a useful reference when checking the low-pressure side. Contamination and a closed manual valve remain obvious mechanical causes.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 2F

Possible causes

  • Voltage drop during cranking, coil cannot lift the armature medium
  • Contaminated or sticking valve E medium
  • Manual valve on cylinder E closed low

Symptoms

  • Check engine light
  • Cylinder E does not empty
  • Fault appears mainly after cold or weak-battery starts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P2A2F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication