P2A2E
Alternative Fuel Tank Shutoff Valve E Control Circuit/Open
P2A2E is the open-circuit fault for shutoff valve E, the last letter of this series, so it only applies to systems with at least five gas cylinders, such as transit buses or heavy trucks. The module notices that the coil draws no current when commanded. No manufacturer documents P2A2E publicly, and TransEco's AFCM table lists valve E only with its Low and High codes. New Flyer offers a practical check: if the engine fails to start, confirm that the door of the fill box is shut and the solenoid wires are plugged in, because an open door also keeps all tank valves shut. Swapping the coil with a neighbour tells a coil fault from a wiring fault. CARB's monitoring rules for output components apply.
Possible causes
- Valve E connector not plugged in after tank work high
- Open coil of valve E medium
- Broken wire in the harness branch to tank E medium
Symptoms
- Check engine light
- Gas in cylinder E remains unused
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A2E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.