P2A29
Alternative Fuel Tank Shutoff Valve C Control Circuit High
P2A29 sets when the drive circuit of shutoff valve C sits at a high level, as with a wire touching battery voltage or a driver stage inside the module that will not switch off. TransEco's table for its AFCM v1.4 gives a short to power as the cause, with the MIL on and gas operation maintained. Ford names P2A29 in its Boss 302S code list. GM's bi-fuel Impala powers the cut-off solenoid on its tank only while the engine cranks or runs; a valve that remains live afterwards defeats the purpose of the lock, which is to hold gas in the cylinder when the vehicle stands or the fuel supply has been cut. Wiring mistakes after a conversion deserve a look. P2A28 is the low-side code for valve C.
Possible causes
- Valve C control wire in contact with battery voltage high
- Driver stage for valve C will not switch off medium
- Valve C wired to a permanent feed after a conversion low
Symptoms
- Check engine light
- Cylinder C not sealed when the engine is off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A29
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.