P2A28
Alternative Fuel Tank Shutoff Valve C Control Circuit Low
P2A28 tells that the control line of shutoff valve C reads too low. In TransEco Energy's AFCM table the cause is a lead to ground or an interruption; the MIL lights in both dedicated and bi-fuel conversions, and the vehicle continues without a forced change of fuel. Another number, P2A18, appears there alongside. Ford's Boss 302S list of 2014 carries P2A28 too. On cylinders mounted under a truck bed or on a bus roof the harness runs past brackets and clamps, where insulation can wear through. Whether a grounded line leaves the valve shut or pulls it open depends on whether the module switches the supply side or the ground side of the coil. P2A29 covers the high reading, P2A24 the same fault on valve B.
Possible causes
- Insulation of the valve C wire worn through at a clamp high
- Interrupted lead, reported here by some modules medium
- Coil of valve C shorted internally low
Symptoms
- Check engine light
- Cylinder C not used or not shut off correctly
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A28
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.