P2A25
Alternative Fuel Tank Shutoff Valve B Control Circuit High
P2A25 reports a voltage on the control circuit of tank valve B that is higher than the module expects, mostly because the wire touches a battery feed. TransEco Energy's fault table names a short to power as the cause, turns on the MIL and lets the gas system carry on. The real risk lies elsewhere: a solenoid held by foreign voltage stays open even when the module wants the cylinder isolated, for instance after the engine stops. Ford's 2003 bi-fuel CNG documentation shows why that matters, since its module shuts the tank valve once gas pressure falls under 517 kPa. Ford's Boss 302S list names P2A25 as well. P2A24 is the low-side partner; for valve A the equivalent code is P224F.
Possible causes
- Control wire of valve B touching a battery feed high
- Output stage for valve B in the module stuck on medium
- Wiring mistake during conversion or repair low
Symptoms
- Check engine light
- Tank B may stay open with the engine off
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A25
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.