P2A20
Injection Pump Fuel Metering Control F Low (Cam/Rotor/Injector)
P2A20 is the low-signal fault of metering element F: the module measures a voltage or current on that drive line that is lower than the switching state allows. Shorts to ground, broken conductors on low-side switched circuits and connectors pushed out of their housing are the usual suspects. Element F is the sixth individually controlled metering element, so the code only concerns engines with six such units. No manufacturer describes P2A20 publicly; even Volvo, which uses the letter F, lists it only for range/performance. As an analogy, Saab's 2011 9-5 diesel sets P0253 for its regulator line shorted to ground and P0251 for an open line, each after one second, both as Type A faults. The high-signal counterpart of P2A20 is P2A21.
Possible causes
- Drive line of element F shorted to ground high
- Terminal pushed out of the connector housing or broken conductor medium
- Open coil in metering element F low
Symptoms
- Check engine light on
- Reduced power
- Rough idle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A20
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.