P2A1E
Injection Pump Fuel Metering Control F (Cam/Rotor/Injector)
P2A1E is the general fault of the sixth fuel metering element, F – the last letter of this code family. The control module stores it for a failure of that element that it cannot pin down as a plausibility (P2A1F), low (P2A20) or high (P2A21) fault. Six individually metered elements would fit, for example, a six-cylinder engine with one pumping unit or unit injector per cylinder. Volvo and Mack, whose 13 litre truck engines use three cam-driven pumping injectors on a common rail, name element F in service bulletins, but only with the range/performance code P2A1F. No source describes P2A1E itself; the CARB rules for fuel system and electrical components set the frame. Typical consequences are a warning lamp and derated power.
Possible causes
- Wiring or connector fault in the circuit of element F high
- Pumping unit, valve or injector solenoid of element F defective medium
- Engine control module fault low
Symptoms
- Check engine light on
- Derated power
- Uneven running
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A1E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.