P2A1C
Injection Pump Fuel Metering Control E Low (Cam/Rotor/Injector)
P2A1C is set when the drive circuit of the fifth metering element, E, reads below its permitted range. On solenoid-operated pump valves and unit injectors, a wire grounded against the engine block, water in a connector or a broken lead on the ground-switched side are typical. Because only a few injection layouts have five or more separately controlled elements, the code is rare, and no manufacturer documents it publicly. California's comprehensive component monitoring demands checking every such output for breaks and for values outside its range. Saab's two-valve V6 diesel pump of 2002 gives an analogy: a grounded or open common supply (P0258) restricts fuel quantity and rail pressure. Element E's high-side and functional faults are P2A1D and P2A1B.
Possible causes
- Wire of element E rubbing on the engine block and grounded high
- Moisture or corrosion in the connector of element E medium
- Broken lead on the ground-switched side medium
Symptoms
- Check engine light on
- Reduced power or limp mode
- Rough running
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2A1C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- law.cornell.edu/regulations/california/13-CCR-1968.2
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/technical-description/fuel-pressure-valve-fuel-rail
- saabwisonline.com/9-5-9600/2002/2-engine/engine-management-system-v6-diesel/fault-diagnosis-diagnostic-trouble-codes/p0258