P2A1B
Injection Pump Fuel Metering Control E Range/Performance (Cam/Rotor/Injector)
P2A1B reports that metering element E works electrically but its result is off: the pressure build-up or quantity attributed to it deviates from what was commanded, or its correction values sit at the limit. How a control module rates this is not published; rail pressure and fuel correction are the obvious inputs. No manufacturer documents P2A1B. Volvo and Mack use the matching range/performance code for B, D and F – three letters for the three pumping injectors of their 13 litre engines; E does not appear there. California's heavy-duty OBD rule requires detecting a fuel system that can no longer deliver the commanded quantity or pressure. Power is cut back, and a worn cam lobe, plunger or valve is a plausible cause.
Possible causes
- Worn cam lobe, plunger or valve of metering element E high
- Insufficient low-pressure supply or clogged filter medium
- Leak in the high-pressure circuit medium
Symptoms
- Check engine light on
- Lack of power under load
- Longer cranking before start
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A1B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.