P2A1A
Injection Pump Fuel Metering Control E (Cam/Rotor/Injector)
P2A1A covers fuel metering element E in general: the engine control module has seen a malfunction of that element but files it under none of the more specific codes for plausibility (P2A1B) or low and high signal (P2A1C, P2A1D). A fifth separately driven element is rare; it presupposes engines that meter fuel per cylinder or per pumping unit. Delphi's F2E heavy-duty system, used by Volvo, Renault Trucks and Hyundai on six-cylinder engines, pairs a common rail with six injectors, half of them pumping and half plain, and the 16 litre version uses six pumping injectors – a layout where letters up to F could be assigned. Whether any maker actually reports P2A1A is not published; the CARB monitoring rules remain the basis. Reduced power is the likely reaction.
Possible causes
- Wiring or connector fault at metering element E high
- Metering element E or its solenoid defective medium
- Control module fault low
Symptoms
- Check engine light on
- Reduced power
- Uneven idle
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2A1A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.