OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A14

Injection Pump Fuel Metering Control C Low (Cam/Rotor/Injector)

P2A14 reports that the signal in the drive circuit of fuel metering element C has fallen below its expected window. In practice the control module sees too little voltage or current on that output, as happens when the line touches ground or, depending on the driver design, an open wire. C denotes a third metering element besides A and B, found only on pumps or engines with several separately driven elements. No maker documents P2A14 publicly. Saab's 2011 9-5 diesel shows how such a check works for its single regulator: a control line shorted to ground for longer than one second sets P0253 as an immediate Type A fault. California's comprehensive component rules require this circuit check for every such actuator. Limited power and rough running are typical; P2A15 is the high-side counterpart.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 14

Possible causes

  • Control wire of element C chafed through and shorted to ground high
  • Broken wire or corroded, loose connector pin in the element C circuit medium
  • Coil of metering element C open or shorted to its housing medium
  • Faulty output stage in the engine control module low

Symptoms

  • Check engine light on
  • Reduced power or limp mode
  • Rough running or misfire-like shaking

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2A14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication