OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A11

O2 Sensor Negative Voltage Bank 2 Sensor 3

P2A11 is assigned to bank 2's third oxygen sensor, located after a second converter or additional aftertreatment of a two-bank engine, and says its signal has gone negative. For an intact, properly connected zirconia sensor that is not a normal state; likely explanations are reversed leads, a short within the harness or a cracked sensing element. No manufacturer documents P2A11 publicly, and for the whole series P2A06–P2A11 no public monitor description could be found; this text draws on CARB's rule on implausible sensor values, on Ford's rear-sensor test (below −0.2 V held over 10 s, filed as P2A01/P2A04) and on Denso's crack-detection patent. P2A08 is the bank-1 counterpart. Effects on driving are minimal, while the monitor that depends on this sensor stays incomplete.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 11

Possible causes

  • Leads swapped or harness short near the exhaust high
  • Cracked sensing element of sensor 3 medium
  • Fault in the module's sensor input low

Symptoms

  • Check engine light on
  • Dependent catalyst or aftertreatment monitor incomplete

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A11

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication