P2A10
O2 Sensor Negative Voltage Bank 2 Sensor 2
The downstream oxygen sensor of bank 2, behind that bank's converter, is reporting a negative voltage. Bank 2 only exists on V and flat engines. A healthy switching sensor swings between roughly 0.1 and 0.9 V; readings below zero come from swapped signal and return wires, for instance after splicing in a universal sensor, from a fouled reference air path or from a cracked ceramic. No manufacturer documents P2A10 publicly. Ford monitors precisely this condition on rear sensors with a limit of −0.2 V held over 10 s but stores P2A04 for bank 2. A Denso patent treats negative readings during fuel cut-off as a sign of an element crack. The engine itself runs normally, but converter monitoring on bank 2 is blocked until the cause is fixed.
Possible causes
- Signal and return wires swapped, e.g. on a spliced universal sensor high
- Cracked ceramic of the bank 2 downstream sensor medium
- Reference air path fouled low
Symptoms
- Check engine light on
- Catalyst monitor of bank 2 not ready
- No change in driving behaviour
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2A10
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.