P2A0C
Manifold Absolute Pressure Sensor B Circuit Low
P2A0C reports that the MAP B signal voltage is too low. Manifold pressure sensors are usually three-wire parts fed from a 5 V reference; a signal close to zero means a broken reference or signal wire, a ground short or a dead sensor, because even deep vacuum would not pull a healthy sensor down that far. GM documents the code for the Corvette's LT6 V8, whose sensor B measures the manifold pressure of bank 2: a reading below 0.5 V for 1.5 s sets it after one trip. The bank-1 sensor reports the same condition as P0107. Once the signal is lost the module falls back on a modelled pressure for that bank, so the engine keeps running, but response and smoothness may suffer and power may be cut back.
Possible causes
- 5 V reference or signal wire open high
- Signal wire shorted to ground medium
- Sensor B failed internally medium
Symptoms
- Check engine light on
- Sluggish response or rough running
- Possible reduced engine power
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2A0C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.