OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A0B

Manifold Absolute Pressure Sensor B Circuit Range/Performance

P2A0B means the MAP B signal stays inside its electrical range but does not fit the operating state. GM documents it for the Corvette's LT6 V8, where sensor B reads the bank-2 manifold pressure, with several checks: before the engine turns, the raw reading has to agree with ambient pressure within a few kPa, otherwise one trip and 5 s are enough; with the engine running it is held against a modelled manifold pressure and may not overshoot the model's maximum or undershoot its minimum by more than about 2 kPa; and if the signal moves by less than 10 kPa although conditions should make it vary, the sensor is treated as frozen (two trips). Leaks downstream of the throttle, a blocked sensor port, ice or a drifting sensor are typical reasons.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 0B

Possible causes

  • Air leak in the bank 2 intake behind the throttle high
  • Sensor port blocked by deposits or frozen condensate medium
  • Sensor B drifting so that its reading no longer matches ambient or model medium

Symptoms

  • Check engine light on
  • Hesitation or uneven idle
  • Mixture or load faults on bank 2

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A0B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication