P2A0A
Manifold Absolute Pressure Sensor B Circuit
Engines with two intake manifold pressure sensors call the second one sensor B; in GM's tables for the Corvette's LT6 V8 it measures the manifold pressure of bank 2, next to the bank-1 sensor that uses the familiar P0105–P0109 codes. P2A0A is the general circuit fault of sensor B, meant for cases where the module sees a circuit problem without sorting it into low, high or intermittent. No manufacturer documents P2A0A publicly – the LT6 tables split electrical faults of this sensor into P2A0C and P2A0D. CARB requires checks for broken circuits and implausible extremes on every input that affects emissions. Without a usable MAP B signal the module estimates the air charge of the affected bank from a model, which can cost smoothness and power.
Possible causes
- Loose connector, corroded terminal or damaged wire at sensor B high
- MAP sensor B failed internally medium
- 5 V reference shared with other sensors pulled down low
Symptoms
- Check engine light on
- Uneven running or hesitation
- Possible reduced power
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for P2A0A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.