P2A08
O2 Sensor Negative Voltage Bank 1 Sensor 3
P2A08 is the negative-voltage fault of the third oxygen sensor on bank 1, which sits behind a second converter or another aftertreatment stage. Such a sensor is normally a zirconia switching type whose output should stay above zero; an intact, correctly wired sensor does not deliver a negative reading in normal operation, so the code suggests swapped leads, a short between the signal return and another circuit, or a cracked element. No manufacturer documents P2A08 publicly; this description rests on CARB's duty to catch open circuits and readings outside the valid band, on Ford's −0.2 V limit for rear sensors (stored there under range codes) and on a Denso patent for crack detection. Sensor 3 hardly influences mixture control, so the main consequence is an incomplete converter monitor.
Possible causes
- Signal return shorted to another circuit or leads swapped high
- Cracked sensing element of sensor 3 medium
- Fault in the module's sensor input stage low
Symptoms
- Check engine light on
- Converter monitor readiness missing
- Normal driving behaviour in most cases
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2A08
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.