OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A05

O2 Sensor Circuit Range/Performance Bank 2 Sensor 3

P2A05 refers to the third oxygen sensor on bank 2, mounted behind a further converter or aftertreatment stage of a V or flat engine. No manufacturer documents this code publicly. The nearest documented case is its bank-1 counterpart: GM's 2025 diesel tables compare the oxygen value of sensor 3 with that of sensor 2 at full load and set P2A02 when the gap exceeds 6 % in 120 of 240 samples. Ford's downstream checks show the other route into a range fault, a reading that sinks below −0.2 V, which Ford, however, files only for sensor 2. CARB requires downstream sensors to stay good enough for the monitors that rely on them. An implausible sensor 3 goes largely unnoticed while driving, but the converter or aftertreatment check of bank 2 cannot finish.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 05

Possible causes

  • Third sensor on bank 2 drifting or slow with age high
  • Exhaust leak in the pipe between sensor 2 and sensor 3 medium
  • Damaged or heat-affected wiring under the vehicle low

Symptoms

  • Check engine light on
  • Readiness for the catalyst or aftertreatment monitor missing
  • Usually no change in driving behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2A05

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication