OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2A04

O2 Sensor Circuit Range/Performance Bank 2 Sensor 2

Sensor 2 on bank 2 is the oxygen sensor behind that bank's catalytic converter, used for converter monitoring and fine mixture trim. Ford documents P2A04 together with P2A01 for certain Continental control modules on petrol engines from 2011, and again in its 2020–2023 summary: a rear-sensor voltage that stays below −0.2 V over 10 s sets the code – a value an intact switching sensor should not produce, normally pointing to swapped signal and return wires or a worn sensor. Mazda's CX-9 (2007–2015) logs P2A04 for the left-hand downstream sensor, often together with P2272; bulletins SA-004/18 and SA-004/19 send the technician to look for oil from a leaking oil pressure switch in connector C-34 before replacing the sensor. Driveability rarely suffers, but converter monitoring on bank 2 stops.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / 04

Possible causes

  • Oil in the sensor connector from a leaking oil pressure switch (Mazda CX-9) high
  • Downstream sensor on bank 2 worn high
  • Signal and return wires swapped or sensors of both banks plugged in crosswise medium

Symptoms

  • Check engine light on
  • Often stored together with a stuck-lean code for the same sensor
  • Catalyst monitor of bank 2 not ready

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for P2A04

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication