OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28F9

Exhaust Pressure Too Low Bank 1

P28F9 flags exhaust pressure on bank 1 that stays below what the engine should produce at the current load. Too little pressure ahead of the turbine means the gas is escaping or not being held back: a leak at the manifold, gasket or turbine inlet, an exhaust flap jammed open, or a variable turbine stuck wide open. No manufacturer documents P28F9 publicly. Ford's 2023 diesel summary shows how such a deviation can be caught: it compares the measured turbine upstream pressure with a modelled value and flags differences beyond -100 or +500 kPa, but files them under P0474 as a sensor fault. A system-level code like P28F9 instead assumes the sensor is right. CARB requires underboost monitoring on boosted engines. Expect weak boost, sluggish response and possibly louder exhaust noise.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / F9

Possible causes

  • Exhaust leak at manifold, gasket or turbine inlet on bank 1 high
  • Variable turbine geometry stuck in the open position medium
  • Exhaust throttle or pressure flap jammed open medium
  • Leaking or cracked sensing tube to the exhaust pressure sensor low

Symptoms

  • Check engine light on
  • Weak boost and sluggish acceleration
  • Ticking or hissing exhaust noise near the manifold

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P28F9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication