OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28F7

Exhaust Pressure Too High Bank 1

P28F7 reports that the pressure in the exhaust of bank 1 is higher than the engine model allows. GM documents it in its 2025 diesel ECM tables (25OBDG04B): the monitor looks at the low-pressure EGR differential pressure and fails above 80 kPa while torque demand exceeds a speed-dependent minimum (around 520 Nm at low engine speed, falling to 20 Nm at high speed), counting 480 failures in 600 samples; it is Type A, MIL on the first trip. GM names the cause as an exhaust throttle valve in the wrong position, for example with the link between its upper and lower shafts broken so the plate can stay shut although the actuated shaft has moved. GM bulletin 21-NA-149 lists P28F7 for the 3.0 L LM2 Duramax. Excess back pressure costs power and fuel and stresses the turbocharger.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / F7

Possible causes

  • Exhaust throttle valve stuck closed or its shaft linkage broken high
  • Exhaust restricted downstream, for example by a heavily loaded particulate filter or damaged pipe medium
  • Chafed engine harness disturbing valve control (GM 21-NA-149) low
  • Pressure sensor reading too high without a separate sensor code low

Symptoms

  • Check engine light on
  • Reduced engine power
  • Higher fuel consumption and more frequent filter regenerations

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P28F7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 4 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication