P28F5
Engine Disconnect Clutch Pressure Sensor Circuit Intermittent/Erratic
P28F5 covers a pressure signal from the engine disconnect clutch that jumps, drops out briefly or changes faster than the hydraulics physically allow. Each sample may sit inside the valid band, but the pattern points to a loose contact, a wire that breaks under vibration or heat, or an unstable sensor. No manufacturer documents P28F5 publicly. Ford's bulletin for the 10R80 hybrid gearbox shows that this sensor sits on the outside of the clutch circuit with its own seal and fasteners; a loose fit there leaks fluid and can also disturb the connector. CARB requires checks for erratic input signals. In contrast to P28F2, which concerns a steady but implausible value, P28F5 is about an unsteady one. The driver may notice sporadic warnings and uneven engine engagement.
Possible causes
- Loose or corroded terminal in the sensor or transmission connector high
- Harness wire breaking intermittently under vibration or heat medium
- Sensor loose on its mounting or internally unstable medium
Symptoms
- Hybrid warning that comes and goes
- Occasional jerk when the engine is coupled in
- Fluid seepage at the sensor in some cases
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28F5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.