P28F0
Engine Disconnect Clutch Actuator Stuck On
P28F0 is the opposite of P28EF: the actuator of the engine disconnect clutch keeps applying the clutch although the controller wants it released. The engine then stays tied to e-machine and wheels, so electric-only driving and engine stop at standstill are no longer possible. No manufacturer documents P28F0 publicly. A Hyundai patent explains how such a fault is found: with the clutch commanded open, the speeds on both sides of it are compared, and if they still match, the clutch is judged stuck; the controller then blocks engine restarts that could push torque straight to the drive shaft. CARB treats the clutch actuator as a monitored hybrid output. P2886 names a clutch stuck closed itself, while P28F0 blames the actuator. Expect stalling or shudder at stops.
Possible causes
- Clutch pressure valve stuck in the applied position, for example by debris high
- Valve or actuator driver permanently energised by a short in wiring or module medium
- Clutch plates overheated and dragging so the actuator cannot release them low
Symptoms
- Engine stalls or shudders when the car comes to a stop
- No electric-only driving, engine runs all the time
- Hybrid system warning and restricted engine restarts
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P28F0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.