P28E8
Shift Motor Position Sensor Circuit High
P28E8 means the shift motor position sensor reports a value above its permitted range. Kia documents it on the 2024-25 EV9: service action SA594 (bulletin ELE362, January 2025) covers cars built from 25 September 2023 to 4 September 2024 that may not leave Park while P28E812 is stored, which Kia attributes to an output shaft sensor reading above what it should be. The fix is new software for the shift control unit, event 787, an improvement of the fault judgment logic, also offered over the air. Outside that campaign the usual causes apply: a signal line shorted to a supply, an open sensor ground or a failed sensor. A Denso patent describes such output shaft sensors with two independent channels. CARB requires out-of-range checks on inputs. P28E9 is the low fault.
Possible causes
- Shift control unit software on the 2024-25 Kia EV9 (service action SA594) high
- Sensor signal shorted to supply or battery voltage medium
- Open or high-resistance sensor ground medium
- Position sensor failed with output stuck high low
Symptoms
- Vehicle cannot be shifted out of Park
- Shift system warning in the cluster
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P28E8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.