P28E7
Shift Motor Position Sensor Circuit/Open
The shift motor position sensor tells the controller where the selector shaft of a shift-by-wire actuator stands. In a Denso patent it is a contactless magnetic sensor on the detent plate with two independent units, so two signals reach the ECU; Hyundai notes in bulletin 22-AT-001H that the readings of its two position sensors should add up to roughly 100 percent. P28E7 marks a broken circuit: no usable signal arrives, typically because the signal, supply or ground lead is interrupted or the plug has been pulled. No manufacturer documents P28E7 itself publicly; Kia uses the High variant P28E8. CARB requires circuit checks on inputs. Without a confirmed position the system cannot verify Park, so it may refuse to shift or to start.
Possible causes
- Position sensor connector loose, corroded or unplugged high
- Signal, supply or ground wire of the sensor broken medium
- Position sensor failed internally medium
Symptoms
- Shift system warning in the cluster
- Gear display missing or wrong
- Vehicle refuses to shift or does not start
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P28E7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.