OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28E1

Shift Motor Phase U-V-W Circuit High

P28E1 is the opposite of P28E0: on any of the three shift motor phases the controller sees a voltage that is higher than the switching state allows, for example while the low-side switch should pull it down. Likely reasons are a phase lead touching a battery-powered wire, a winding with an internal short to a live part, or a high-side switch in the driver that no longer turns off. No manufacturer documents P28E1 publicly. The hardware is the same as described in a Denso shift range patent, where a motor driver feeds the U, V and W phases and a relay can disconnect the motor, and in Hyundai Kefico's brushless SBW actuator. CARB requires circuit checks on outputs. With a phase held high the motor cannot be commutated, so range changes stop.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / E1

Possible causes

  • Phase lead shorted to a battery-voltage wire in the harness high
  • High-side switch in the shift control unit stuck on medium
  • Water or corrosion bridging pins in the actuator connector low

Symptoms

  • Shift system warning in the cluster
  • No response to the gear selector
  • Vehicle may remain in Park

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28E1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication