OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28DE

Clutch B Pressure Sensor Circuit High

P28DE means the clutch B pressure sensor delivers a voltage above anything a working sensor would show, even at full clutch pressure. Typical causes are a signal line touching a supply or battery feed, a broken sensor ground, or a signal line open at the sensor end where the input uses a pull-up resistor. No manufacturer documents P28DE publicly. In the actuator layout of a Getrag patent the pressure at each clutch is set by the speed of its own pump motor and checked by a pressure sensor, so a falsely high value would lead the controller to under-apply the clutch; an Audi patent shows the same one-sensor-per-clutch idea. Out-of-range checks on this kind of input are a CARB requirement. P28DD is the low fault and P28CF the clutch A version. The module usually disables clutch B.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / DE

Possible causes

  • Signal wire shorted to the sensor supply or to battery voltage high
  • Sensor ground open or high resistance at the connector medium
  • Pressure sensor failed with output stuck high medium

Symptoms

  • Transmission warning or check engine light on
  • Emergency mode with limited gears
  • Slipping or weak pull when clutch B is in use

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28DE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication