OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28DD

Clutch B Pressure Sensor Circuit Low

Set when the voltage from the clutch B pressure sensor falls below the lowest value the part can produce in normal service. Usually the signal line has a short to ground, the sensor supply is missing or the sensor has failed internally. Because the reading lies outside the valid band, the module treats it as an electrical fault rather than as low pressure. No manufacturer documents P28DD publicly. Patents from Getrag and Audi place one pressure sensor at every clutch of a twin-clutch gearbox so the controller can regulate clutch pressure directly; under CARB rules such inputs need an out-of-range check. P28DE is the high counterpart, P28DC the open circuit and P28CE the same fault on clutch A. Shifts that need clutch B may be blocked.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / DD

Possible causes

  • Sensor signal wire chafed through and shorted to ground high
  • Sensor supply voltage missing or pulled down by another shorted sensor on the same supply medium
  • Pressure sensor electronics failed medium

Symptoms

  • Transmission warning or check engine light on
  • Transmission in emergency mode, some gears unavailable
  • Harsh or delayed engagement

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28DD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication