OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28DC

Clutch B Pressure Sensor Circuit/Open

P28DC concerns the sensor that reports the hydraulic pressure acting on clutch B of a dual-clutch or hybrid transmission. The code points to a broken connection: the module receives no usable signal at all, as happens when a signal, supply or ground wire is open or the connector has come off. No manufacturer documents P28DC publicly. A Getrag patent shows why the reading matters: each clutch has its own actuator pump with a dedicated electric drive, and the measured pressure closes the loop over motor speed; an Audi patent likewise gives every clutch its own pressure sensor. CARB requires circuit checks on such inputs. Which clutch carries the letter B is up to the maker. Without the signal the module runs clutch B on a fallback or takes it out of use.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / DC

Possible causes

  • Connector at the sensor or transmission plug loose, unplugged or with a pushed-back pin high
  • Signal, supply or ground wire of the sensor broken medium
  • Pressure sensor internally open medium
  • Sensor input in the transmission control module faulty low

Symptoms

  • Transmission warning or check engine light on
  • Gears served by clutch B blocked, transmission in emergency mode
  • Jerky launch or harsh shifts

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28DC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication