OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28DA

Clutch B Motor Position Sensor Circuit/Open

P28DA concerns the electrical circuit of the sensor that reports the rotor angle of the clutch B motor, and is chiefly stored when that signal disappears because a line is open. Electronic commutation of a brushless motor relies on this angle to energise U, V and W in the right order; it also lets the controller count revolutions and compare pump speed with the pressure sensor. Without a valid signal the clutch B pump is stopped and the gears on that shaft are no longer offered. Usual culprits are a broken sensor supply or ground, a pin pushed out of the connector, or a dead Hall or magnetic element inside the actuator. P28DB handles a signal that exists but is inconsistent; P28CB is the clutch A equivalent. Details are unpublished.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / DA

Possible causes

  • Open supply, ground or signal line of the clutch B motor position sensor high
  • Pin pushed out or bent at the clutch B actuator connector medium
  • Failed sensing element inside the clutch B actuator medium

Symptoms

  • Clutch B out of service, half of the gears missing
  • Transmission warning lamp on
  • Motor speed codes for clutch B may be stored as follow-up faults

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28DA

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication