OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28D8

Clutch B Motor Overspeed

P28D8 sets when the clutch B motor spins faster than the controller expects for the commanded pressure. A gerotor works by positive displacement, the EVS32 model uses one with a seven-tooth outer rotor, so in a sealed clutch circuit its speed should fall once pressure is built; a motor that keeps accelerating means oil is escaping or the pump has lost its load. Plausible reasons are a worn piston or rotary seal in the clutch B circuit, aeration from low oil, or a sheared drive between motor shaft and inner rotor. A false speed reading from the rotor position sensor can mimic the same, so P28DA and P28DB should be cleared first. Slow running is P28D9; on clutch A the code is P28C9. No limits are published.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / D8

Possible causes

  • Worn piston or rotary feedthrough seal letting oil escape from the clutch B circuit high
  • Aerated oil due to low level, pump runs without load medium
  • Sheared drive between clutch B motor shaft and inner rotor low
  • Rotor position sensor reporting an excessive speed low

Symptoms

  • Clutch B does not hold full torque, flaring on shifts
  • Transmission warning and limited gears

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28D8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication