P28D7
Clutch B Pump Motor Performance
P28D7 judges motor and pump of clutch B as one unit: the oil pressure seen by the sensor, or the speed and current the motor needs for it, does not match the target. Getrag's hydraulic plan for the 7DCT300 has both clutch pumps drawing through a common suction filter, with a pressure sensor downstream of both pumps providing feedback. If P28D7 and the clutch A code P28C8 are stored together, the shared filter or the oil level is therefore a natural suspect; P28D7 on its own points more towards the clutch B pump, its gerotor set or leaking seals in the clutch B circuit. An EVS32 study with Hyundai found such on-demand pumps cut actuation energy by 96.5 % in the WLTP versus an engine-driven pump. No manufacturer documents P28D7 publicly.
Possible causes
- Clogged common suction filter, especially if P28C8 is stored too high
- Leaking seals in the clutch B pressure circuit medium
- Worn or contaminated gerotor set of the clutch B pump medium
- Transmission fluid level too low low
Symptoms
- Clutch B slips or engages late
- Transmission warning, gears on clutch B possibly locked out
- Unusual humming from the actuator area
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28D7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.