P28D6
Clutch B Motor Driver Current/Temperature Too High
P28D6 tells that the electronic switch stage powering the clutch B motor has hit its overcurrent or overtemperature protection. Normally these pump actuators draw very little; Getrag quotes roughly 31 W (NEDC) and 33 W (WLTC) for the complete 7DCT300 actuation, so a stage running into its limits indicates the motor is working against unusual resistance or a fault in the stage itself. Candidates include a pump seized by particles, which Stellantis reports for the 7HDT300 actuator under P28D5, a shorted motor winding, or long stretches of high clamping demand while the clutch is already hot, as P27F3 would show. Wiring faults on the phases fall under P28D2-P28D4; the clutch A counterpart is P28D1. Limits are not public.
Possible causes
- Clutch B pump seized by particles, motor stalls and draws excess current high
- Turn-to-turn short in the clutch B motor winding medium
- Prolonged high pressure demand with hot clutch, e.g. stop-and-go or towing medium
- Defective output stage or poor heat transfer in the controller low
Symptoms
- Clutch B shut down temporarily, may recover after cooling
- Transmission warning and restricted gears
- May appear together with P27F3 or P28D5
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28D6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.