P28D4
Clutch B Motor Phase U-V-W Circuit/Open
P28D4 covers the circuit of the three motor phases for clutch B in general and is mainly logged when the controller energises a phase and no current returns, meaning the path is broken. Getrag chose brushless ferrite motors without rare earths for this pump-actuator generation and reused them from the 6DCT250; if one winding path is lost, the remaining two cannot turn the rotor smoothly, and the gerotor pump of clutch B stops delivering oil to the clutch piston. Loose crimp terminals, a fractured wire near the actuator, or an internal connection cracked by heat cycles are the usual finds. P28D2/P28D3 describe phases forced low or high; P28C6 is the same fault on clutch A. No manufacturer has published P28D4 details.
Possible causes
- Loose or spread crimp terminal on a clutch B motor phase high
- Phase wire fractured close to the clutch B actuator medium
- Internal winding joint in the clutch B motor cracked by thermal cycling medium
Symptoms
- Clutch B cannot be closed, its gears are blocked
- Fault may appear only on rough roads or when hot
- Transmission warning, MIL depending on make
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28D4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.