P28D3
Clutch B Motor Phase U-V-W Circuit High
P28D3 is the high-voltage fault on the phase wiring of the clutch B motor: a lead reads above what the inverter pattern should produce, typically because it contacts a positive feed or the upper switch cannot turn off. In the Getrag 7DCT300 five brushless motors share the housing, two for the shift drums, two for the clutch pumps and one for the cooling pump, so motor harnesses run close together and a chafed spot can bridge to a neighbouring supply. Pin corrosion in the connector is a further candidate. P28D2 is the ground-side fault, P28D4 the interruption, and P28C5 the matching clutch A code. Values are not public. The transmission controller usually disables clutch B and drives on the other half.
Possible causes
- Clutch B motor phase touching a neighbouring positive feed in the harness high
- Corroded pins bridging at the clutch B motor connector medium
- Upper output switch for the clutch B motor stays conducting low
Symptoms
- Warning lamp and stored fault code
- Vehicle drives on with only one clutch, gear choice reduced
- Possible jerk when the controller drops clutch B
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28D3
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.