OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28D2

Clutch B Motor Phase U-V-W Circuit Low

P28D2 reports that on the U, V or W lead feeding the electric drive of clutch B a voltage below its expected level is measured, pointing to a short towards ground. Such motor-driven clutches are found in wet dual-clutch units of the Getrag/Magna pump-actuator family; the 7DCT300 went into series in 2015 with the Renault Espace, and the hybrid 7HDT300 uses the same principle. In the Stellantis hybrid version clutch B carries the even gears. Frequent triggers are insulation rubbed through on a bracket, water in the actuator plug or a failed low-side transistor. Overvoltage on a phase is P28D3, an open lead P28D4; P28C4 is the clutch A twin. No carmaker publishes a limit; the even-shaft gears may be withheld.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / D2

Possible causes

  • Insulation of a clutch B motor phase rubbed through against ground high
  • Water or corrosion in the clutch B actuator plug pulling a phase low medium
  • Failed low-side transistor of the clutch B motor driver low

Symptoms

  • Transmission warning light, MIL possible
  • Gears on the clutch B shaft unavailable (even gears on the 7HDT300)
  • Harsh or hesitant gear changes

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28D2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication