P28CF
Clutch A Pressure Sensor Circuit High
P28CF means the voltage from the clutch A pressure sensor climbs above the band a plausible measurement can reach, usually close to the reference or battery voltage. An open ground line is a frequent trigger, because many sensor circuits then float up to the supply level; a signal wire touching the 5-volt or 12-volt feed, or a sensor with a broken internal element, has the same effect. To the controller this would look like maximum clutch pressure, so it cannot trust the closed-loop pump control and normally deactivates clutch A to avoid unintended engagement. The low-side counterpart is P28CE and the general circuit code P28CD. No manufacturer publicly documents P28CF.
Possible causes
- Open ground wire of the clutch A pressure sensor high
- Signal wire shorted to the 5-volt reference or battery voltage medium
- Pressure sensor failed with output stuck high low
Symptoms
- Transmission warning, clutch A taken out of service
- Pull-away or shifts only on the other clutch
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28CF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.