OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28CE

Clutch A Pressure Sensor Circuit Low

P28CE is logged when the clutch A pressure sensor output drops below the lowest voltage a working sensor can produce. Ratiometric pressure sensors are usually designed so that even zero pressure gives a small offset voltage; a reading underneath that band therefore means an electrical fault, not low pressure. Classic causes are a signal wire shorted to ground, a collapsed 5-volt reference shared with other sensors, or an internal short in the sensor. If the reference is the problem, several sensor codes often appear together. The pressure closed loop of the pump actuator then lacks feedback and clutch A is typically switched off. P28CF is the high-side twin; no manufacturer publicly documents P28CE values.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / CE

Possible causes

  • Pressure sensor signal wire shorted to ground high
  • 5-volt reference pulled down by another sensor on the same supply medium
  • Internally shorted clutch A pressure sensor medium

Symptoms

  • Clutch A disabled with transmission warning
  • Other sensor codes may be stored at the same time
  • Reduced choice of gears

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28CE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication