OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28CD

Clutch A Pressure Sensor Circuit/Open

P28CD concerns the pressure sensor that tells the transmission controller how much oil pressure acts on clutch A. In pump-actuated wet DCTs there is no proportional valve to set pressure; instead Getrag places a pressure sensor downstream of the clutch pumps and closes the control loop over motor speed. P28CD is the general circuit fault, chiefly an interrupted signal, supply or ground line, so the controller receives no usable reading at all. Without feedback it cannot dose clutch torque and will normally take clutch A out of service. P28CE and P28CF describe a signal stuck at the low or high end, P28D0 a value that is in range but wrong. No manufacturer publicly documents P28CD.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / CD

Possible causes

  • Open signal, 5-volt supply or ground wire of the clutch A pressure sensor high
  • Sensor connector not fully latched or pin pushed out medium
  • Internal open in the pressure sensor low

Symptoms

  • Clutch A shut off, half of the gears unavailable
  • Transmission warning lamp and stored code

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28CD

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication