OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28CC

Clutch A Motor Position Sensor Circuit Range/Performance

P28CC is the plausibility counterpart to P28CB: the position signal of the clutch A motor arrives, but its values or their sequence make no sense, for example jumps between rotor angles, a missing step in the pattern, or a speed that contradicts the phase currents. CARB expects rationality checks of this kind for input components where feasible. Electrical noise from a damaged shield, a partially broken wire, a loose sensor mount or magnet, and contamination of the sensor target are typical reasons. Since commutation depends on this signal, the motor may stutter, overshoot or stall, which can also produce P28C9 or P28CA. No manufacturer publicly documents P28CC; the result for the driver is lost or rough engagement of clutch A.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / CC

Possible causes

  • Electrical interference on the position signal through a damaged shield medium
  • Partly broken wire or loose contact causing signal dropouts high
  • Loose sensor, shifted magnet or contaminated sensor target low

Symptoms

  • Clutch A engages roughly or intermittently
  • Transmission warning, sometimes only while driving
  • Gear changes on one shaft delayed or withheld

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28CC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication