OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P28CB

Clutch A Motor Position Sensor Circuit/Open

A brushless motor can only be commutated correctly if the electronics know where the rotor stands; P28CB reports that the signal from the sensor tracking the clutch A motor's rotor position is missing or electrically unusable, mostly through an open line. Without it the controller cannot switch the U-V-W phases in the right order or count motor revolutions, so the pump of clutch A is shut down. In Getrag-type pump actuators these brushless ferrite motors are shared parts, and the position signal also serves to check motor speed against the pressure target. Typical causes: an open sensor feed or ground, a corroded pin, a failed sensor element. P28CC covers a signal that is present but implausible. No manufacturer publishes P28CB details.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / number8 / CB

Possible causes

  • Open signal, supply or ground wire of the clutch A motor position sensor high
  • Corroded or loose pin at the actuator connector medium
  • Failed position sensor inside the actuator medium

Symptoms

  • Clutch A disabled, gears on that shaft unavailable
  • Transmission warning lamp
  • Possibly also motor speed codes stored

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P28CB

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication