P28CA
Clutch A Motor Underspeed
P28CA means the clutch A motor stays below the speed the controller commands, so the pump cannot deliver oil fast enough to build or modulate clutch pressure. Mechanical drag is the usual culprit: particles wedged in the gerotor, a seized bearing, or very thick oil in deep cold. Stellantis reports debris blocking an actuator pump on the 7HDT300 (bulletin 21-040-26), though it lists P28C7 rather than this code. Electrical limits can play a part as well, for instance low supply voltage or the controller derating its output stage because of heat, which would appear as P28D1. Overspeed of the same motor is P28C9. No manufacturer documents P28CA with a threshold; engagement of clutch A becomes slow or fails.
Possible causes
- Particles jamming the gerotor pump of clutch A high
- Stiff or seized motor/pump bearing medium
- Low supply voltage to the actuator or poor ground low
Symptoms
- Clutch A engages late or with a jolt
- Transmission warning, especially after cold start
- Affected gears may be withheld
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P28CA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.